<[email protected]> writes:
> From: Manikanta <[email protected]>
>
> This patch adds support for getting firmware debug stats in 10.4 fw.
>
> Signed-off-by: Tamizh chelvam <[email protected]>
This patch adds new warnings:
drivers/net/wireless/ath/ath10k/wmi.c:7121:6: warning: symbol
'ath10k_wmi_10_4_fw_stats_fill' was not declared. Should it be static?
drivers/net/wireless/ath/ath10k/wmi.c:7122: Alignment should match open
parenthesis
drivers/net/wireless/ath/ath10k/wmi.h:6323: Alignment should match open
parenthesis
And while testing this I found this buggy:
root@lainahp:/sys/kernel/debug/ieee80211/phy0/ath10k# tail -20 fw_stats
MPDU errors (FCS, MIC, ENC) 0
Num Rx Overflow errors 0
ath10k VDEV stats (0)
=================
ath10k PEER stats (2)
=================
Peer MAC address 02:00:00:00:03:00
Peer RSSI 0
Peer TX rate 5120
Peer RX rate 0
Peer MAC address 00:00:00:00:10:68
Peer RSSI 34236
Peer TX rate 31
Peer RX rate 0
The last two bytes of the client's mac address are bc:85 and 34236 is
0x85bc so ath10k is definitely not parsing the peer stats correctly.
I used:
[ 68.077601] ath10k_pci 0000:02:00.0: pci irq msi interrupts 1 irq_mode 0
reset_mode 0
[ 72.516344] ath10k_pci 0000:02:00.0: qca99x0 hw2.0 (0x01000000, 0x003801ff
bmi 1:1) fw 10.4.1.00030-1 fwapi 5 bdapi 2 htt-ver 2.2 wmi-op 6 htt-op 4 cal
otp max-sta 512 raw 0 hwcrypto 1 features no-p2p
[ 72.516468] ath10k_pci 0000:02:00.0: debug 1 debugfs 1 tracing 1 dfs 1
testmode 1
--
Kalle Valo
_______________________________________________
ath10k mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/ath10k
