From: Alan Liu <[email protected]> QCA6174 WLAN.RM.2.0 firmware uses max_tx_power instead of using max_reg_power to set transmission power. The tx power was about -50dbm, after applying this change, it become -32dbm.
Signed-off-by: Alan Liu <[email protected]> Signed-off-by: Kalle Valo <[email protected]> --- v2: * rename the patch from: Add max_tx_power member to set max transmission power for WLAN.RM.2.0 firmware. to: ath10k: add max_tx_power for QCA6174 WLAN.RM.2.0 firmware * CC ath10k list * add an empty line drivers/net/wireless/ath/ath10k/wmi.c | 1 + drivers/net/wireless/ath/ath10k/wmi.h | 1 + 2 files changed, 2 insertions(+) diff --git a/drivers/net/wireless/ath/ath10k/wmi.c b/drivers/net/wireless/ath/ath10k/wmi.c index a1afb2e2b05a..260070db2512 100644 --- a/drivers/net/wireless/ath/ath10k/wmi.c +++ b/drivers/net/wireless/ath/ath10k/wmi.c @@ -1633,6 +1633,7 @@ void ath10k_wmi_put_wmi_channel(struct wmi_channel *ch, ch->max_power = arg->max_power; ch->reg_power = arg->max_reg_power; ch->antenna_max = arg->max_antenna_gain; + ch->max_tx_power = arg->max_power; /* mode & flags share storage */ ch->mode = arg->mode; diff --git a/drivers/net/wireless/ath/ath10k/wmi.h b/drivers/net/wireless/ath/ath10k/wmi.h index db2553522d8b..fe36b2c99018 100644 --- a/drivers/net/wireless/ath/ath10k/wmi.h +++ b/drivers/net/wireless/ath/ath10k/wmi.h @@ -1795,6 +1795,7 @@ struct wmi_channel { __le32 reginfo1; struct { u8 antenna_max; + u8 max_tx_power; } __packed; } __packed; } __packed; -- 1.7.9.5 _______________________________________________ ath10k mailing list [email protected] http://lists.infradead.org/mailman/listinfo/ath10k
