Thanks! I mostly am interested in knowing the modulation just to keep track of my theoretical maximum throughput for monitoring. The Rx rate was changing correctly now, which is great. I know the Tx rate is totally unreported, but the Rx is all I need. Thanks again for all the assistance, I think I have everything I need.
Zach On Fri, May 6, 2016 at 11:56 AM, Yeoh Chun-Yeow <[email protected]> wrote: > Rate control is done in HW. Not minstrel. Tx Rate reporting is not > there in "iw mesh0 station dump", only Rx Rate. > > But by the way, you can set the tx bit rate manually. Refer: > https://wireless.wiki.kernel.org/en/users/drivers/ath10k/debug > > ---- > Chun-Yeow > > On Fri, May 6, 2016 at 11:49 PM, Raj Joshi <[email protected]> wrote: >> >> On May 6, 2016 11:30 PM, "Yeoh Chun-Yeow" <[email protected]> wrote: >>> >>> Try use the "iw wlanX station dump" and check the rx bitrate. >> >> Just curious, wouldn't the rate control algorithm change the rate? Minstrel >> HT - the default one? >> >> I mean, can one actually fix the settings such as VHT MCS 9 + 3 Streams + >> Short GI + 80 MHz channel width and every frame that is sent out *obeys* >> this fixed setting? It would be interesting to know if there is any such way >> - helpful for experimental measurement studies :) >> >> Raj Joshi >> >>> ---- >>> Chun-Yeow >>> >>> On Fri, May 6, 2016 at 10:28 PM, Zach Sherin <[email protected]> wrote: >>> > That is embarrassing that I trusted OpenWRT to have tried that. It >>> > would appear that I can set the frequency manually. Thank you! >>> > >>> > On a related note, is there any way to check the modulation that the >>> > radio is using? I'd like to check all the parameters possible in >>> > order to understand my throughput numbers. >>> > >>> > Thanks again for the fix! >>> > Zach >>> > >>> > On Thu, May 5, 2016 at 9:32 PM, Bob Copeland <[email protected]> wrote: >>> >> On Thu, May 05, 2016 at 02:51:27PM -0400, Zach Sherin wrote: >>> >>> Is there any way to increase channel widths in 802.11s? If this is an >>> >>> OpenWRT question and not ath10k I'll head over to the forums, but this >>> >>> seemed more a driver issue as my wireless config requests wide >>> >>> channels. Any chance there's a specific version of ath10k I should >>> >>> push to? >>> >> >>> >> I'm not sure about OpenWRT's scripts but you can specify the channel >>> >> width >>> >> when setting the frequency (before joining the mesh). >>> >> >>> >> E.g.: >>> >> >>> >> ip link set wlan0 up >>> >> iw dev wlan0 set freq 5745 80 5775 >>> >> iw dev wlan0 mesh join my-vht-mesh >>> >> >>> >> -- >>> >> Bob Copeland %% http://bobcopeland.com/ >>> > >>> > _______________________________________________ >>> > ath10k mailing list >>> > [email protected] >>> > http://lists.infradead.org/mailman/listinfo/ath10k >>> >>> _______________________________________________ >>> ath10k mailing list >>> [email protected] >>> http://lists.infradead.org/mailman/listinfo/ath10k _______________________________________________ ath10k mailing list [email protected] http://lists.infradead.org/mailman/listinfo/ath10k
