Hi all, I'm working on a device with antenna selection, similar to the ideas behind Ruckus or Google's Onhub router. I've been looking into a solution for per-packet antenna selection (based on destination/next hop). I was hoping this list might be able to suggest where I should investigate adding that switching code. My switches are currently USB RF switches, but I'm going to be using some serial protocol for the final version (we don't have much to switch, and it should be a single byte per packet).
The last suggestion I received was to emulate Netsed [1] by routing all packets through a specific socket, running antenna selection, and then pushing them to their final destinations. I assumed that the best place to do antenna selection would be within ath10k itself (my devices all run on ath10k) so that I could introduce the minimum possible latency with antenna selection. Should I be looking at a different part of the networking stack? Does anyone have any suggestions, or perhaps an open-source project out there already trying to do antenna selection? Thanks, Zach [1] http://silicone.homelinux.org/projects/netsed/ _______________________________________________ ath10k mailing list [email protected] http://lists.infradead.org/mailman/listinfo/ath10k
