Hi Michal, That does help. Thank you so much.
GN. On Wed, Jun 8, 2016 at 5:14 AM, Michal Kazior <[email protected]> wrote: > On 8 June 2016 at 11:01, Gaurang Ramesh Naik <[email protected]> wrote: >> Hi, >> >> I know there is an iw command to set the number of transmission >> retries using "iw phy phyx set retry short 'y' long 'z'". When I used >> this command though, I did not observe any change in the performance >> of the link throughput. Does ath10k honor this command? Also, if it >> does, is it implemented in the firmware, or open-source? > > ath10k does not honour it. > > As far as I understand you want to alter number of retries with regard > to RTS/CTS being used or not. If so I'm not aware of any mechanism to > tell that to firmware (this is rate-control related and rate-control > is offloaded by firmware entirely). > > To my knowledge what you can do is change number of software retries > for aggregated and non-aggregated traffic via NON_AGG_SW_RETRY_TH and > AGG_SW_RETRY_TH WMI's pdev parameters. Perhaps you'll find this > useful. > > > Michał _______________________________________________ ath10k mailing list [email protected] http://lists.infradead.org/mailman/listinfo/ath10k
