Hi Ben, Thanks for your reply.
I wanted to know if the dynamic bandwidth option implemented in ath10k is the same as that mentioned in the standard, or does it deviate? I tried to look for any documentation on ath10k dynamic bandwidth, but could not find any. If I am not wrong, on the secondary channel, the sender senses the channel for PIFS interval of time immediately preceding the start of the TXOP (9.19.2.8 in the standard). In the static mode, if the secondary channel is sensed busy, the sender waits until all channels become idle; but in the dynamic mode, the sender sends on the primary and (adjacent) secondary channel that are not busy. However, the documentation for dynamic bandwidth in ath10k/mac.c seems to suggest that the transmission retries are carried over narrower bandwidth in dynamic mode. Does this mean the same as what is given in the standard? Or is the dynamic mode implemented differently? Any help is appreciated. Thanks, Gaurang. On Thu, Jun 9, 2016 at 1:23 AM, Ben Greear <[email protected]> wrote: > > > On 06/08/2016 08:10 PM, Gaurang Ramesh Naik wrote: >> >> Hi, >> >> I needed a small clarification related to dynamic bandwidth setup. The >> documentation in wmi.h says " When enabled HW rate control tries >> different bandwidths when retransmitting frames." >> >> Does this mean that each packet is first always tried over VHT80 and >> if that fails it goes to HT40 and then to HT20? I tried this with one >> AP-Sta operating in VHT80 and one AP operating in its first secondary >> channel. When I check the rx rate info using "iw dev wlanx station >> dump", the bandwidth seems to sometimes alternate between 20 and 80, >> but sometimes it stays fixed at 20. Hence, I was wondering what really >> happens. > > > For one thing, if the hardware detects interference on secondary channels, > then it may decide to transmit a 20Mhz encoding. > > The rate-ctrl algs in the firmware differ from release to release, but > the general goal is to transmit with the fastest encoding rate. > > Thanks, > Ben > >> >> Thanks, >> Gaurang. >> >> _______________________________________________ >> ath10k mailing list >> [email protected] >> http://lists.infradead.org/mailman/listinfo/ath10k >> > > -- > Ben Greear <[email protected]> > Candela Technologies Inc http://www.candelatech.com _______________________________________________ ath10k mailing list [email protected] http://lists.infradead.org/mailman/listinfo/ath10k
