[email protected] writes: > From: Ben Greear <[email protected]> > > CT firmware can support IBSS mode, so allow users to configure this. > > Signed-off-by: Ben Greear <[email protected]> > --- > drivers/net/wireless/ath/ath10k/mac.c | 5 +++++ > 1 file changed, 5 insertions(+) > > diff --git a/drivers/net/wireless/ath/ath10k/mac.c > b/drivers/net/wireless/ath/ath10k/mac.c > index f1bfb3a..3fc9006 100644 > --- a/drivers/net/wireless/ath/ath10k/mac.c > +++ b/drivers/net/wireless/ath/ath10k/mac.c > @@ -7482,6 +7482,10 @@ static const struct ieee80211_iface_limit > ath10k_10x_ct_if_limits[] = { > .max = 7, > .types = BIT(NL80211_IFTYPE_AP) > }, > + { > + .max = 1, > + .types = BIT(NL80211_IFTYPE_ADHOC) > + }, > }; > > static const struct ieee80211_iface_combination ath10k_if_comb[] = { > @@ -7862,6 +7866,7 @@ int ath10k_mac_register(struct ath10k *ar) > ar->hw->wiphy->iface_combinations = > ath10k_10x_ct_if_comb; > ar->hw->wiphy->n_iface_combinations = > ARRAY_SIZE(ath10k_10x_ct_if_comb); > + ar->hw->wiphy->interface_modes |= > BIT(NL80211_IFTYPE_ADHOC); > } else { > ar->hw->wiphy->iface_combinations = ath10k_10x_if_comb; > ar->hw->wiphy->n_iface_combinations =
There should a feature flag ATH10K_FW_FEATURE_SUPPORTS_ADHOC and we use that flag as an indication to enable the mode. I wish we had done that from the beginning, using wmi_op_version to guess that just creates problems :( -- Kalle Valo _______________________________________________ ath10k mailing list [email protected] http://lists.infradead.org/mailman/listinfo/ath10k
