On 2017-12-08 17:42, Sven Eckelmann wrote:
On Donnerstag, 25. Mai 2017 16:21:23 CET ako...@qti.qualcomm.com wrote:
From: Anilkumar Kolli <ako...@qti.qualcomm.com>
QCA99X0, QCA9888, QCA9984 supports calibration data in
either OTP or DT/pre-cal file. Current ath10k supports
Calibration data from OTP only.
If caldata is loaded from DT/pre-cal file, fetching board id
and applying calibration parameters like tx power gets failed.
error log:
[ 15.733663] ath10k_pci 0000:01:00.0: failed to fetch board file: -2
[ 15.741474] ath10k_pci 0000:01:00.0: could not probe fw (-2)
This patch adds calibration data support from DT/pre-cal
file. Below parameters are used to get board id and
applying calibration parameters from cal data.
EEPROM[OTP] FLASH[DT/pre-cal file]
Cal param 0x700 0x10000
Board id 0x10 0x8000
Tested on QCA9888 with pre-cal file.
Signed-off-by: Anilkumar Kolli <ako...@qti.qualcomm.com>
---
drivers/net/wireless/ath/ath10k/bmi.h | 2 ++
drivers/net/wireless/ath/ath10k/core.c | 16 +++++++++++++---
2 files changed, 15 insertions(+), 3 deletions(-)
Just tried this on an QCA9984 which doesn't seem to have the
calibration data in the PCI EEPROM.
[ 71.728929] ath10k_pci 0000:01:00.0: qca9984/qca9994 hw1.0
target 0x01000000 chip_id 0x00000000 sub 168c:cafe
[ 71.732926] ath10k_pci 0000:01:00.0: kconfig debug 1 debugfs 1
tracing 0 dfs 1 testmode 1
[ 71.752282] ath10k_pci 0000:01:00.0: firmware ver
10.4-ct-9984-fW-009-dfa0083 api 5 features peer-flow-ctrl crc32
7198d117
[ 73.805730] ath10k_pci 0000:01:00.0: unable to read from the
device
[ 73.805769] ath10k_pci 0000:01:00.0: could not execute otp for
board id check: -110
'ATH10K driver <-> 10.4 firmware' expects cal data to be either in
EEPROM or pre-cal-file or DT.
Hope the error is observed when there is no cal data loaded.
It works when I use the pre-cal data as calibration data. The checksum
in the
pre-cal seems to be correct. Also the pre-cal data from 0:ART for the
2.4GHz
and 5GHz QCA4019 seem to work perfectly fine.
Do you mean this patch works for only QCA4019 and not working for
QCA9984 ?
Anything which I could have missed or what I could test? Btw. I've also
tested
the non-ct firmware (aka the official one from QCA).
Thanks,
Anil.
_______________________________________________
ath10k mailing list
ath10k@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/ath10k
