Hello, we at CZ.NIC are trying the current ath10k driver with High Latency + SDIO support (which was done by Silex Technology) on our board. The supported chip, QCA9377, works, but we only have 1x1 MIMO boards with this chip. We are trying to get it work with 8274B-SR (QCA6174) ( http://www.fn-link.com/a-b-g-n-ac-wi-fi-bt-module/8274b-sr.html )
There is already some code in sdio.c mentoining QCA6174, but there are no nodes in ath10k_hw_params. Because QCA6174 is supported via PCI bus, I tried to write the ath10k_hw_params node (see patch http://blackhole.sk/~kabel/src/qca6174.patch ) but do not know if the changes I did are enough, because the driver fails after loading firmware. And the firmware is another point: Does board-sdio.bin have to be different from board.bin? Do we have to create this binary ourselves, or should the 8274B-SR board manufacturer sent us one? (We didn't receive anything from fn-link.) Any information is good, please let us know even if you have NDA on this and therefore cannot give any more information about this. Thank you. Marek Behun, CZ.NIC _______________________________________________ ath10k mailing list [email protected] http://lists.infradead.org/mailman/listinfo/ath10k
