On Thu, 2018-08-30 at 16:32 -0700, Grant Grundler wrote: > On Sun, Aug 12, 2018 at 10:37 PM Wen Gong <[email protected]> wrote: > ... > > I have tested with your method for shift 6/8/10/7 all twice time in open > > air environment. > > I've attached the graphed data which Wen provided me and I made one > "cleanup": the median and average "ICMP" are computed only using > values where flent has an "antagonist" load running. The first 28 and > last 26 seconds of the test are "idle" - it makes no sense to include > the latency of those. This drops about 1/7th of the data points. > > My observations: > o the delta between average and median is evidence this is not > particularly reliable data (but expected result for "open air" wifi > testing in a corp environment). > o sk_pacing_shift=8 and/or =7 appears to have suffered from > significant open air interference - I've attached a graph of the raw > data. > o I'm comfortable asserting throughput is higher and latency is lower > for sk_pacing_shift=6 (vs 7) at the cost of additional CPU > utilization. > > My questions: > 1) Is the current conversation just quibbling about 6 vs 7 for the > ath10k default?
6 vs. 8, I think? But I didn't follow the full discussion. I also think that we shouldn't necessarily restrict this to "for the ath10k". Is there any reason to think that this would be different for different chips? I could see a reason for a driver to set the default *higher* than the mac80211 default (needing more buffers for whatever internal reason), but I can't really see a reason it should be *lower*. Also, the networking-stack wide default is 0, after all, so it seems that each new layer might have some knowledge about why to *increase* it (like mac80211 knows that A-MPDUs/A-MSDUs need to be built), but it seems not so reasonable that it should be reduced again. Unless you have some specific knowledge that ath10k would have a smaller A-MSDU/A-MPDU size limit or something? > 2) If yes, can both patches be accepted and then later add code to > select a default based on CPU available? I've applied the first patch now (with some comment cleanups, you may want to pick those up for your internal usage) because I can see an argument for increasing it. However, I think that the "quibbling" over the default should most likely result in a changed default value for mac80211, rather than ath10k using the driver setting as a way out of that discussion. johannes _______________________________________________ ath10k mailing list [email protected] http://lists.infradead.org/mailman/listinfo/ath10k
