Wen Gong <[email protected]> writes:
> For WoWLAN support, it expect to support wake up based on discovery of
> one or more known SSIDs. This is the WIPHY_WOWLAN_NET_DETECT feature,
> which shows up as an NL80211 feature flag.
>
> With an upgrade iw, this shows up in 'iw phy' as:
> WoWLAN support:
> * wake up on network detection, up to 16 match sets
> And it can use command:
> "iw phy0 wowlan enable net-detect interval 5000 delay 30 freqs 2412
> matches ssid foo" to configure the parameters of net detect.
>
> Firmware will do scan by the configured parameters after suspend and
> wakeup if it found matched SSIDs. Tested with QCA6174 hw3.0 with
> firmware WLAN.RM.4.4.1-00110-QCARMSWPZ-1.
>
> Signed-off-by: Wen Gong <[email protected]>
[...]
> +/* Request FW to start PNO operation */
> +static struct sk_buff *ath10k_wmi_tlv_op_gen_config_pno_start
> + (struct ath10k *ar,
> + u32 vdev_id,
> + struct wmi_pno_scan_req *pno)
> +{
> + struct wmi_tlv_wow_nlo_config_cmd *cmd;
> + struct wmi_tlv *tlv;
> + struct sk_buff *skb;
> + struct nlo_configured_parameters *nlo_list;
> + u32 *channel_list;
[...]
> + channel_list = (u32 *)ptr;
> + for (i = 0; i < cmd->num_of_channels; i++)
> + channel_list[i] = pno->a_networks[0].channels[i];
channel_list does not look endian safe to me, I'll change this to use
__le32.
> +enum wmi_nlo_cipher_algorithm {
> + WMI_NLO_CIPHER_ALGO_NONE = 0x00,
> + WMI_NLO_CIPHER_ALGO_WEP40 = 0x01,
> + WMI_NLO_CIPHER_ALGO_TKIP = 0x02,
> + WMI_NLO_CIPHER_ALGO_CCMP = 0x04,
> + WMI_NLO_CIPHER_ALGO_WEP104 = 0x05,
> + WMI_NLO_CIPHER_ALGO_BIP = 0x06,
> + WMI_NLO_CIPHER_ALGO_WPA_USE_GROUP = 0x100,
> + WMI_NLO_CIPHER_ALGO_RSN_USE_GROUP = 0x100,
Two defines with the same value 0x100, is this really correct?
--
Kalle Valo
_______________________________________________
ath10k mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/ath10k
