Johannes Berg <[email protected]> writes: > On Wed, 2018-09-05 at 18:01 -0700, Pradeep Kumar Chitrapu wrote: >> Currently ftm_responder parameter in hostapd.conf is only used for fine >> timing measurement (FTM) capability advertisement and actual control of >> the functionality is with low-level device/driver. This leads to confusion >> to the user when the capability advertisement is different from actual FTM >> responder functionality. >> >> For example, FTM responder capability advertisement is set to 'enabled', >> but the functionality is disabled or not supported by the driver. >> >> The patch set allows userspace to enable FTM responder functionality >> with the addition of new Netlink flag attribute NL80211_ATTR_FTM_RESPONDER >> with configurable lci/civic ocation parameters. Also extended feature flag >> is added for the drivers to advertise the support. Setting the flag to >> enable FTM responder would imply that AP responds to all FTM requests. >> Default is considered to be disabled. >> >> changes in V3: >> - fixed the ambiguous ftm responder disable case to be not supported > > For reasons unknown to me, this patchset made it neither to the list > nor, consequently, patchwork. Please resend.
Actually patch 3 made it: https://patchwork.kernel.org/patch/10590115/ But it didn't get the rest as it says "Untitled series #15763". Patchwork was timing out for me quite heavily so in that way I'm not surprised that patches are getting lost :( -- Kalle Valo _______________________________________________ ath10k mailing list [email protected] http://lists.infradead.org/mailman/listinfo/ath10k
