On 8/10/20 3:08 PM, Ahmed Zaki wrote:
Hello,
I have 2 ath10k devices set in Mesh Point mode. When I use iptables'
DSCP target to set the WMM AC for some traffic ports to VO, the rules
work fine but only for unicast packets. All broadcast on the target
UDP ports goes out as BE, and not VO.
With some ath10k debugging enabled, it seems that the htt is indeed
sending the tx descriptor with the correct tid (6) set.
Is this the intended behavior for some reason? If not, is there any
more debugging on the TX path that I can do?
I don't think that WMM makes sense for bcast frames since they go out on
a special TID that does not do aggregation or per peer QoS settings.
Thanks,
Ben
--
Ben Greear <[email protected]>
Candela Technologies Inc http://www.candelatech.com
_______________________________________________
ath10k mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/ath10k
