Hi,
If you don't mind, I'd like ask a few questions regarding QCA6174 firmwares.
1. I've notice that QCA6174 hw3.0 4.4.1 firmwares have 4 versions (none, c1,
c2, c3). Are there any differences? Which one is newest or correct?
2. My QCA6174 seems to have a compatibility issue with a recent firmware. I've
tested theses firmware versions, but only the oldest one works.
RM.4.4.1.c2-00057-QCARMSWP-1 (debian oldstable's stock firmware, 20190114-2,
work's fine):
ath10k_pci 0000:01:00.0: pci irq msi oper_irq_mode 2 irq_mode 0 reset_mode 0
ath10k_pci 0000:01:00.0: firmware: failed to load
ath10k/pre-cal-pci-0000:01:00.0.bin (-2)
ath10k_pci 0000:01:00.0: firmware: failed to load
ath10k/cal-pci-0000:01:00.0.bin (-2)
usbcore: registered new interface driver ath3k
ath10k_pci 0000:01:00.0: firmware: direct-loading firmware
ath10k/QCA6174/hw3.0/firmware-6.bin
ath10k_pci 0000:01:00.0: qca6174 hw3.0 target 0x05020000 chip_id 0x003409ff sub
168c:3361
ath10k_pci 0000:01:00.0: kconfig debug 0 debugfs 0 tracing 0 dfs 0 testmode 0
ath10k_pci 0000:01:00.0: firmware ver RM.4.4.1.c2-00057-QCARMSWP-1 api 6
features wowlan,ignore-otp,no-4addr-pad,raw-mode crc32 e061250a
ath10k_pci 0000:01:00.0: firmware: direct-loading firmware
ath10k/QCA6174/hw3.0/board-2.bin
ath10k_pci 0000:01:00.0: board_file api 2 bmi_id N/A crc32 20d869c3
ath10k_pci 0000:01:00.0: htt-ver 3.56 wmi-op 4 htt-op 3 cal otp max-sta 32 raw
0 hwcrypto 1
WLAN.RM.4.4.1-00157-QCARMSWPZ-1 (debian stable's stock firmware, 20210315-3):
ath10k_pci 0000:01:00.0: pci irq msi oper_irq_mode 2 irq_mode 0 reset_mode 0
ath10k_pci 0000:01:00.0: firmware: failed to load
ath10k/pre-cal-pci-0000:01:00.0.bin (-2)
ath10k_pci 0000:01:00.0: firmware: failed to load
ath10k/cal-pci-0000:01:00.0.bin (-2)
ath10k_pci 0000:01:00.0: firmware: direct-loading firmware
ath10k/QCA6174/hw3.0/firmware-6.bin
ath10k_pci 0000:01:00.0: qca6174 hw3.0 target 0x05020000 chip_id 0x003409ff sub
168c:3361
ath10k_pci 0000:01:00.0: kconfig debug 0 debugfs 0 tracing 0 dfs 0 testmode 0
ath10k_pci 0000:01:00.0: firmware ver WLAN.RM.4.4.1-00157-QCARMSWPZ-1 api 6
features wowlan,ignore-otp,mfp crc32 90eebefb
ath10k_pci 0000:01:00.0: firmware: direct-loading firmware
ath10k/QCA6174/hw3.0/board-2.bin
ath10k_pci 0000:01:00.0: board_file api 2 bmi_id N/A crc32 318825bf
ath10k_pci 0000:01:00.0: wmi unified ready event not received
ath10k_pci 0000:01:00.0: device has crashed during init
ath10k_pci 0000:01:00.0: device has crashed during init
ath10k_pci 0000:01:00.0: failed to wait for target init: -70
ath10k_pci 0000:01:00.0: could not init core (-110)
ath10k_pci 0000:01:00.0: could not probe fw (-110)
WLAN.RM.4.4.1-00288- (most recent version?):
ath10k_pci 0000:01:00.0: pci irq msi oper_irq_mode 2 irq_mode 0 reset_mode 0
ath10k_pci 0000:01:00.0: firmware: failed to load
ath10k/pre-cal-pci-0000:01:00.0.bin (-2)
ath10k_pci 0000:01:00.0: firmware: failed to load
ath10k/cal-pci-0000:01:00.0.bin (-2)
ath10k_pci 0000:01:00.0: firmware: direct-loading firmware
ath10k/QCA6174/hw3.0/firmware-6.bin
ath10k_pci 0000:01:00.0: qca6174 hw3.0 target 0x05020000 chip_id 0x003409ff sub
168c:3361
ath10k_pci 0000:01:00.0: kconfig debug 0 debugfs 0 tracing 0 dfs 0 testmode 0
ath10k_pci 0000:01:00.0: firmware ver WLAN.RM.4.4.1-00288- api 6 features
wowlan,ignore-otp,mfp crc32 bf907c7c
ath10k_pci 0000:01:00.0: board_file api 2 bmi_id N/A crc32 318825bf
ath10k_pci 0000:01:00.0: wmi unified ready event not received
ath10k_pci 0000:01:00.0: device has crashed during init
ath10k_pci 0000:01:00.0: device has crashed during init
ath10k_pci 0000:01:00.0: failed to wait for target init: -70
ath10k_pci 0000:01:00.0: could not init core (-110)
ath10k_pci 0000:01:00.0: could not probe fw (-110)
Kernel: Linux XXXX 5.10.0-16-amd64 #1 SMP Debian 5.10.127-2 (2022-07-23) x86_64
GNU/Linux
My lspci info:
01:00.0 Network controller [0280]: Qualcomm Atheros QCA6174 802.11ac Wireless
Network Adapter [168c:003e] (rev 30)
Subsystem: Qualcomm Atheros QCA6174 802.11ac Wireless Network Adapter
[168c:3361]
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B- DisINTx+
Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort-
<MAbort- >SERR- <PERR- INTx-
Latency: 0, Cache Line Size: 64 bytes
Interrupt: pin A routed to IRQ 150
IOMMU group: 12
Region 0: Memory at 7fc00000 (64-bit, non-prefetchable) [size=2M]
Capabilities: [40] Power Management version 3
Flags: PMEClk- DSI- D1- D2- AuxCurrent=375mA
PME(D0+,D1-,D2-,D3hot+,D3cold+)
Status: D0 NoSoftRst- PME-Enable- DSel=0 DScale=0 PME-
Capabilities: [50] MSI: Enable+ Count=1/8 Maskable+ 64bit-
Address: fee005f8 Data: 0000
Masking: 000000fe Pending: 00000000
Capabilities: [70] Express (v2) Endpoint, MSI 00
DevCap: MaxPayload 256 bytes, PhantFunc 0, Latency L0s
unlimited, L1 <64us
ExtTag- AttnBtn- AttnInd- PwrInd- RBE+ FLReset-
SlotPowerLimit 10.000W
DevCtl: CorrErr- NonFatalErr- FatalErr- UnsupReq-
RlxdOrd+ ExtTag- PhantFunc- AuxPwr- NoSnoop-
MaxPayload 256 bytes, MaxReadReq 512 bytes
DevSta: CorrErr- NonFatalErr- FatalErr- UnsupReq- AuxPwr+
TransPend-
LnkCap: Port #0, Speed 2.5GT/s, Width x1, ASPM L0s L1, Exit
Latency L0s <4us, L1 <64us
ClockPM+ Surprise- LLActRep- BwNot- ASPMOptComp+
LnkCtl: ASPM Disabled; RCB 64 bytes, Disabled- CommClk+
ExtSynch- ClockPM+ AutWidDis- BWInt- AutBWInt-
LnkSta: Speed 2.5GT/s (ok), Width x1 (ok)
TrErr- Train- SlotClk+ DLActive- BWMgmt- ABWMgmt-
DevCap2: Completion Timeout: Not Supported, TimeoutDis+
NROPrPrP- LTR+
10BitTagComp- 10BitTagReq- OBFF Via message, ExtFmt-
EETLPPrefix-
EmergencyPowerReduction Not Supported,
EmergencyPowerReductionInit-
FRS- TPHComp- ExtTPHComp-
AtomicOpsCap: 32bit- 64bit- 128bitCAS-
DevCtl2: Completion Timeout: 50us to 50ms, TimeoutDis- LTR+
OBFF Disabled,
AtomicOpsCtl: ReqEn-
LnkCap2: Supported Link Speeds: 2.5GT/s, Crosslink- Retimer-
2Retimers- DRS-
LnkCtl2: Target Link Speed: 2.5GT/s, EnterCompliance- SpeedDis-
Transmit Margin: Normal Operating Range,
EnterModifiedCompliance- ComplianceSOS-
Compliance De-emphasis: -6dB
LnkSta2: Current De-emphasis Level: -6dB, EqualizationComplete-
EqualizationPhase1-
EqualizationPhase2- EqualizationPhase3-
LinkEqualizationRequest-
Retimer- 2Retimers- CrosslinkRes: unsupported
Capabilities: [100 v2] Advanced Error Reporting
UESta: DLP- SDES- TLP- FCP- CmpltTO- CmpltAbrt- UnxCmplt-
RxOF- MalfTLP- ECRC- UnsupReq- ACSViol-
UEMsk: DLP- SDES- TLP- FCP- CmpltTO- CmpltAbrt- UnxCmplt-
RxOF- MalfTLP- ECRC- UnsupReq- ACSViol-
UESvrt: DLP+ SDES+ TLP- FCP+ CmpltTO- CmpltAbrt- UnxCmplt-
RxOF+ MalfTLP+ ECRC- UnsupReq- ACSViol-
CESta: RxErr- BadTLP- BadDLLP- Rollover- Timeout-
AdvNonFatalErr-
CEMsk: RxErr- BadTLP- BadDLLP- Rollover- Timeout-
AdvNonFatalErr+
AERCap: First Error Pointer: 00, ECRCGenCap- ECRCGenEn-
ECRCChkCap- ECRCChkEn-
MultHdrRecCap- MultHdrRecEn- TLPPfxPres- HdrLogCap-
HeaderLog: 00000000 00000000 00000000 00000000
Capabilities: [148 v1] Virtual Channel
Caps: LPEVC=0 RefClk=100ns PATEntryBits=1
Arb: Fixed- WRR32- WRR64- WRR128-
Ctrl: ArbSelect=Fixed
Status: InProgress-
VC0: Caps: PATOffset=00 MaxTimeSlots=1 RejSnoopTrans-
Arb: Fixed- WRR32- WRR64- WRR128- TWRR128- WRR256-
Ctrl: Enable+ ID=0 ArbSelect=Fixed TC/VC=ff
Status: NegoPending- InProgress-
Capabilities: [168 v1] Device Serial Number 00-00-00-00-00-00-00-00
Capabilities: [178 v1] Latency Tolerance Reporting
Max snoop latency: 3145728ns
Max no snoop latency: 3145728ns
Capabilities: [180 v1] L1 PM Substates
L1SubCap: PCI-PM_L1.2+ PCI-PM_L1.1+ ASPM_L1.2+ ASPM_L1.1+
L1_PM_Substates+
PortCommonModeRestoreTime=50us PortTPowerOnTime=10us
L1SubCtl1: PCI-PM_L1.2- PCI-PM_L1.1- ASPM_L1.2- ASPM_L1.1-
T_CommonMode=0us LTR1.2_Threshold=81920ns
L1SubCtl2: T_PwrOn=10us
Kernel driver in use: ath10k_pci
Kernel modules: ath10k_pci
Best Regards,
Wonsup Yoon
_______________________________________________
ath10k mailing list
ath10k@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/ath10k
