The driver is reading the value using the function
"of_property_read_u8", which is expecting the data to be
represented on 8 bits.
By default, the value specified in the DT is saved using a 32 bits
format, which cause the driver to read "0" instead of "1".
To make the driver work properly, the DT should specify the right
data representation to use.
Signed-off-by: Vincent Tremblay <vinc...@vtremblay.dev>
---
v2 changes:
- Remove unrelated changes
.../devicetree/bindings/net/wireless/qcom,ath10k.txt | 6 +++---
1 file changed, 3 insertions(+), 3 deletions(-)
diff --git a/Documentation/devicetree/bindings/net/wireless/qcom,ath10k.txt
b/Documentation/devicetree/bindings/net/wireless/qcom,ath10k.txt
index b61c2d5a0ff7..4a66ceeb1e76 100644
--- a/Documentation/devicetree/bindings/net/wireless/qcom,ath10k.txt
+++ b/Documentation/devicetree/bindings/net/wireless/qcom,ath10k.txt
@@ -92,8 +92,8 @@ Optional properties:
- qcom,msa-fixed-perm: Boolean context flag to disable SCM call for statically
mapped msa region.
-- qcom,coexist-support : should contain eithr "0" or "1" to indicate coex
- support by the hardware.
+- qcom,coexist-support : should contain a 8 bits value representing either
+ "0" or "1" to indicate coex support by the hardware.
- qcom,coexist-gpio-pin : gpio pin number information to support coex
which will be used by wifi firmware.
@@ -176,7 +176,7 @@ wifi0: wifi@a000000 {
qcom,msi_addr = <0x0b006040>;
qcom,msi_base = <0x40>;
qcom,ath10k-pre-calibration-data = [ 01 02 03 ... ];
- qcom,coexist-support = <1>;
+ qcom,coexist-support = /bits/ 8 <1>;
qcom,coexist-gpio-pin = <0x33>;
};
--
2.37.2
_______________________________________________
ath10k mailing list
ath10k@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/ath10k
