Hello I tried both of your patches and I have no messages like ath5k phy0: no further txbuf available, dropping packet
anymore. The driver seems to run stable. The only messages that I get now are [445833.299330] ath5k phy0: noise floor calibration timeout (2427MHz) [445917.395285] ath5k phy0: unsupported jumbo But the noise floor calibration message does not appear often and the unsupported jumbo message is not so bad, as far as I know. Thank you very much for the Patches Cheers Willem Am Donnerstag, den 21.01.2010, 23:15 +0100 schrieb Michael Buesch: > On Thursday 21 January 2010 05:51:02 Bob Copeland wrote: > > Here are a couple of fixes to ath5k AP mode that have been > > kicking around for a bit. > > > > The sleep clock is disabled by legacy HAL for AP mode and at > > least one person had beaconing issues as a result of our not > > also doing so. > > > > Although we decided 'fix setup for CAB queue' was not ideal, > > there's no alternative at the moment and the current setup is > > causing problems for people, so IMO we should just take this > > patch as-is for now. > > > > Bob Copeland (2): > > ath5k: dont use external sleep clock in AP mode > > ath5k: fix setup for CAB queue > > > Thanks a lot for these, Bob. I'll test them on my AP. > > Important: Please also add CC:stable to the patches to make > sure they reach the endusers for 2.6.32.x. > 2.6.32.x currently is unusable in AP mode, so these patches > are pretty important fixes (if they actually fix the issues. > But I assume that for now ;) ) > _______________________________________________ ath5k-devel mailing list ath5k-devel@lists.ath5k.org https://lists.ath5k.org/mailman/listinfo/ath5k-devel
