Hello, If I disable + enable wifi on an eeepc 701, I can no longer get it to work until next boot, even if I unload ath5k before. It fail with the same error than if I load it while wifi is disabled.
(Using 2.6.27-rc7-git5) boot ============ ath5k phy0: Atheros AR2425 chip found (MAC: 0xe2, PHY: 0x70) ============ rmmod ath5k ============ ath5k_pci 0000:01:00.0: PCI INT A disabled ============ modprobe ath5k ============ ath5k_pci 0000:01:00.0: PCI INT A -> GSI 18 (level, low) -> IRQ 18 ath5k_pci 0000:01:00.0: setting latency timer to 64 ath5k_pci 0000:01:00.0: registered as 'phy1' ath5k phy1: Support for RF2425 is under development. phy1: Selected rate control algorithm 'pid' ath5k phy1: Atheros AR2425 chip found (MAC: 0xe2, PHY: 0x70) ============ rmmod ath5k ============ ath5k_pci 0000:01:00.0: PCI INT A disabled ============ disable wifi modprobe ath5k ============ ath5k_pci 0000:01:00.0: PCI INT A -> GSI 18 (level, low) -> IRQ 18 ath5k_pci 0000:01:00.0: registered as 'phy2' ath5k phy2: failed to wakeup the MAC Chip ath5k_pci 0000:01:00.0: PCI INT A disabled ath5k_pci: probe of 0000:01:00.0 failed with error -5 ============ rmmod ath5k enable wifi modprobe ath5k ============ ath5k_pci 0000:01:00.0: enabling device (0000 -> 0002) ath5k_pci 0000:01:00.0: PCI INT A -> GSI 18 (level, low) -> IRQ 18 ath5k_pci 0000:01:00.0: setting latency timer to 64 ath5k_pci 0000:01:00.0: registered as 'phy3' ath5k phy3: failed to wakeup the MAC Chip ath5k_pci 0000:01:00.0: PCI INT A disabled ath5k_pci: probe of 0000:01:00.0 failed with error -5 _______________________________________________ ath5k-users mailing list [email protected] https://lists.ath5k.org/mailman/listinfo/ath5k-users
