>> My laptop has an AR242x wireless chip and I can't connect to an AP or >> get scan results under 2.6.28. I don't get any errors so I'm not sure >> where to start. Should this work? >> >> ath5k_pci 0000:04:00.0: enabling device (0000 -> 0002) >> ath5k_pci 0000:04:00.0: PCI INT A -> GSI 17 (level, low) -> IRQ 17 >> ath5k_pci 0000:04:00.0: setting latency timer to 64 >> ath5k_pci 0000:04:00.0: registered as 'phy0' >> phy0: Selected rate control algorithm 'pid' >> ath5k phy0: Atheros AR2425 chip found (MAC: 0xe2, PHY: 0x70) > > Please show the commend you are using to scan and the actual output of > the command.
# ip link set wlan0 up # iwlist wlan0 scanning No scan results 2 networks come up with strong signals if I use my USB wireless adapter. > Please use "iw" to set the correct regulatory domain. The default > domain is too restrictive. How can I do that? I couldn't figure it out from 'iw --help'. - Grant > > -- > Regards, > Pavel Roskin _______________________________________________ ath5k-users mailing list ath5k-users@lists.ath5k.org https://lists.ath5k.org/mailman/listinfo/ath5k-users