On 4 October 2012 15:29, Ben Greear <[email protected]> wrote: > More fun with attenuation and ath9k: > > It seems that the tx-rates do not properly go to lower speeds, > at least in some cases. > > I enabled lots of attenuation, and it gets into a state where the > station drops rates down to around 100Mbps, but the AP side stays with > high tx-rate. From sniffing, it seems that STA starts sending ARPs to AP, > and AP responds, but packet is never received on the STA. I *do* see lots > of rx-crc errors on the station. > > If I force the rate to be MCS-0, then it runs just fine. I haven't yet > tried forcing it to run at higher rates.
Erm. Start with the rate control output (sysfs?) and see what the pass/fail rates are per TX rate. Adrian _______________________________________________ ath9k-devel mailing list [email protected] https://lists.ath9k.org/mailman/listinfo/ath9k-devel
