usualsuspects Wrote: > Great! In further reading of my amp manual it says (re the gain pots) > Your amplifier sounds best with these level controls set to maximum > So it looks like I can turn them all the way up and set attenuation > on the SB2 to match the correct level for my amp. Earlier in this > thread you stated: However when you reduce the signal level, the noise > floor doesn't change so your SNR becomes effectively worse So from a > best sound standpoint would I be better off using the new built in > attenuation or using an external attenuator?
Give it a try - if you don't hear any hiss/hum when the system is inactive, it should be fine. Personally I would prefer limiting the amp, for safety reasons if nothing else. -- seanadams _______________________________________________ audiophiles mailing list [email protected] http://lists.slimdevices.com/lists/listinfo/audiophiles
