Any specific information? General overview is unsolder the crystal and caps, hook up a piece of ribbon cable to the output of the 51 ohm resistors, alternating gnd and signals. One of the signal wires goes to the (now empty) crystal pad connected to the input pin of 74hc04. All the gnd wires on the cable get connected together to a very short piece of wire connected to a convenient gnd point. I unsoldered the toslink connector so I had a hole to run the cable through.
Thats it for the squeeze box. On the DAC end its very specific to my DAC since I already had a reclocker in the circuit. I made a low noise regulator (based on the one from Guido's page) to go from 5V to 3.3V, fed that to the tent clock. The output from the clock goes to the reclocker and a 74HC08 used as a buffer to drive the SB. Thats it! John S. -- JohnSwenson ------------------------------------------------------------------------ JohnSwenson's Profile: http://forums.slimdevices.com/member.php?userid=5974 View this thread: http://forums.slimdevices.com/showthread.php?t=24800 _______________________________________________ audiophiles mailing list [email protected] http://lists.slimdevices.com/lists/listinfo/audiophiles
