gharris999;140139 Wrote: > Two question: > > 1). Can I use both the unbalanced RCA and the balanced XLR analog > outputs of the Transporter simultaneously? >
Yes you can. Each output is driven separately. > > 2). What is the best way to unbalance the Transporter's XLR analog outs > to connect to unbalanced RCA ins on the ATI amp? (I assume that a LoZ > to HiZ transformer is NOT the way to go.) > > Most diagrams that I've seen wire the XLR pins 1 (ground) and 3 > (-audio) to the sleeve on the RCA connector. However, my DAC1 manual > recommends just leaving pin 3 unconnected to avoid "very high levels of > distortion." What is the prefered method for the Transporter? Do NOT ground the unused signal - it should be disconnected. Just wire up + and gnd. See here: http://forums.slimdevices.com/showthread.php?t=27445 Sean -- seanadams ------------------------------------------------------------------------ seanadams's Profile: http://forums.slimdevices.com/member.php?userid=3 View this thread: http://forums.slimdevices.com/showthread.php?t=27946 _______________________________________________ audiophiles mailing list [email protected] http://lists.slimdevices.com/lists/listinfo/audiophiles
