tjw;155821 Wrote: > I have a Bolder modified SB3, elpac wall wart and recently purchased > Lavry DA10. I changed the DA10 to unbalanced by moving the jumpers > per the Lavry instruction manual. I am using XLR (DAC output) to RCA > (stereo input)cables and Cryotweeks coaxial cable (SB3 output) to DAC > (spdif input). > > The Lavry DAC buttons are set to the following: > 1. Mode - stereo > 2. Polarity - invert > 3. PLL - crystal > 4. Input - rca > > The problem is that i get absolutely no sound out of my speakers. The > SB3 volume is set at 34. The DAC volume is set at 18. I have played > with changes to the DAC switches too no avail. > > Any troubleshooting direction would be appreciated.
I don't know that Lavry, but are you supposed to have XLRs for unbalanced opreation? If so, perhaps the cable you are using is wired so that the signal pin is not being used? Check the cable's configuration -i.e what pin on the XLR side goes to the RCAs mid pin, and compare with what XLR connector on the Lavry is used for unbalanced operation. (Unless the Lavry has RCAs for unbalanced operation, in which case you need to use normal RCA to RCA interconnects, of course.) -- P Floding ------------------------------------------------------------------------ P Floding's Profile: http://forums.slimdevices.com/member.php?userid=2932 View this thread: http://forums.slimdevices.com/showthread.php?t=29831 _______________________________________________ audiophiles mailing list [email protected] http://lists.slimdevices.com/lists/listinfo/audiophiles
