pski;557162 Wrote:
> It's a Peavy CS 800 X. "PA" is really the only economical way to get
> 2ohm (or better) output and quality is not so important when it's only
> driving up to 50-60Hz.
>
> http://www.peavey.com/assets/literature/manuals/80301956.pdf
>
> My JBL Pro amp made white smoke. (I think it wasn't properly
> repaired.)
>
> I was running from SBR to crossover (Furman TX 4) via rca-to-1/4" (Yes,
> both + and - are conducted.)
>
> Then from the crossover to the balanced inputs. I checked the pins vs
> the 1/4" plugs and everything is fine with the cables (I've been using
> them for years with the JBL Pro.
>
> I just maxed the crossover point between low and mid and used the mid
> outputs. (It's a 3-way crossover but I've always just used it to
> bi-amp.) I'm running full range now and the sound quality is good.
> Maybe the amp's "quasi-electronic balanced" circuit is doing it's
> thing.
>
> P
Earlier, someone said I would need 10X the power I have now.
This would be 6000 Wpc at 2Ohms. Any suggestions?
{
--
pski
real stereo makes the lights dim on the bass notes.
------------------------------------------------------------------------
pski's Profile: http://forums.slimdevices.com/member.php?userid=15574
View this thread: http://forums.slimdevices.com/showthread.php?t=79834
_______________________________________________
audiophiles mailing list
[email protected]
http://lists.slimdevices.com/mailman/listinfo/audiophiles
