McOz wrote: > I just purchased a new Transporter and I have to crank the volume on my > amp to hear anything - it's very quite. If I turn the volume up on the > Transporter past 50%, it gets choppy and distorted. > > Any ideas? > > Current setup: > - Analog outputs into a Cambridge Audio SR10 > - Transporter firmware version 87 > > > I have an SBT that plays through the same amp, using the same cables > without issue.
Hmmm unusual. First I'd try a Xilinx reset. Remove power, point remote at transporter pressing the 1 key, and restore power at same time. You can quit pressing the 1 key when you see info about Xilinx on the transporter screen. Also, is the transporter used? I recall that there are some settings that relate to connecting direct to an amp with no preamp, but I've never used them. Is the Cambridge only an amp? *Home:* VortexBox 4TB (2.3) > LMS 7.8 > Transporter, Touch, Boom, Radio w/Battery (all ethernet except Radio) *Cottage:* VBA 3TB (2.3) > LMS 7.8 > Touch > Benchmark DAC I, Boom, Radio w/Battery (all ethernet except Radio) *Office:* Win7(64) > LMS 7.8 > Squeezelite *Spares:* Touch(3), Radio(3), Boom, SB3, CONTROLLER *Controllers:* iPhone6 & iPadAir2 (iPeng8 & Squeezepad), CONTROLLER, or SqueezePlay 7.8 on Win7(64) laptop *Files:* ripping: dbpoweramp > FLAC; post-rip: mp3tag, PerfectTunes; Streaming: Spotify ------------------------------------------------------------------------ garym's Profile: http://forums.slimdevices.com/member.php?userid=17325 View this thread: http://forums.slimdevices.com/showthread.php?t=102958 _______________________________________________ audiophiles mailing list [email protected] http://lists.slimdevices.com/mailman/listinfo/audiophiles
