We had the same "mod" on our IS30 and is has been removed for a reason I am not privy to. I did not like it anyway so I am glad it has gone.
PeterS ----- Original Message ----- From: "Jason Armistead" <[EMAIL PROTECTED]> To: "Discussion of issues relating to Soaring in Australia." <[EMAIL PROTECTED]> Sent: Wednesday, September 22, 2004 1:40 PM Subject: RE: [Aus-soaring] IS28 > The GCV method of locking the IS28 canopy is the same as we use at Southern > Cross Gliding Club. > > The attached picture should clarify things. > > Basically the locking pin is attached to a short wire (just in front of the > placard on the side of the rear instrument panel) > > The bar across the canopy (not shown) then sits between the red U shaped > bracket. > > You just close the canopy, slide the pin through the hole, and lock the pin > in place using the round ring (by rotating it forward). The ring and pin can > just be seen dangling below the red U bracket. > > It works very well > > Cheers > > Jason > > > _______________________________________________ Aus-soaring mailing list [EMAIL PROTECTED] To check or change subscription details, visit: http://lists.internode.on.net/mailman/listinfo/aus-soaring
