Coming slightly late to this party, but yes, on fibre links qinq is supported,
but not on copper EA.
In regard to shaping/policing, Telstra POLICE on ingress at both ends with very
low burst values. Telstra should provide you with the detail (we have a table)
and you need to make sure your shape + BC + BE value are within the spec or (as
others have said) you will get crap performance. Also need to remember what
you're counting in the shaping (ie. L2 or L3 sizes) as this will make a
difference too.One of our normal troubleshooting steps for poor performance on
these kind of links is to set the shaper to about 85% of the link speed and see
how it goes then.
regards,Tony.
From: Radek Tkaczyk <[email protected]>
To: "[email protected]" <[email protected]>
Sent: Thursday, 13 July 2017, 11:04
Subject: [AusNOG] QinQ on Telstra Wholesale EA Fibre Services
<!--#yiv5641355508 P {margin-top:0;margin-bottom:0;}-->Hi Guys,
We are looking at deploying a Telstra Wholesale EA Fibre service, and want to
setup some QinQ tagging on the fibre link. Have done them before with AAPT
Wholesale, but not Telstra Wholesale.
Does anyone know if this can be done with TW EA Fibre? Are there any gotchas to
watch out for with them?
Thanks
Radek_______________________________________________
AusNOG mailing list
[email protected]
http://lists.ausnog.net/mailman/listinfo/ausnog
_______________________________________________
AusNOG mailing list
[email protected]
http://lists.ausnog.net/mailman/listinfo/ausnog
