Check you are setting your baud rate correctly for that switch. https://www.dell.com/support/article/us/en/04/how11279/dell-emc-networking-default-console-settings-for-powerconnect-x-series-n-series-on-series-chassis-series-s-series-switches-z-series-switches?lang=en
Simon. On Thu, 2 May 2019 at 15:00, Daniel Watson <[email protected]> wrote: > Hi Guys > > I’ve just installed a refurb Dell PowerConnect 5448 into Equinix ME1. > However I am having a seriously bad time getting console into the device to > reset the config. > > I have tried plugging a serial cable in directly from the switch into a > servers Com1 port, also tried a USB to serial cable on my laptop. > > Wondering if anyone else might have any tricks up their sleeves? Or if > they know any other way I can factory reset this switch without console? > > Cheers > DW > > Sent from my iPhone > _______________________________________________ > AusNOG mailing list > [email protected] > http://lists.ausnog.net/mailman/listinfo/ausnog > -- Dicko.
_______________________________________________ AusNOG mailing list [email protected] http://lists.ausnog.net/mailman/listinfo/ausnog
