Hello,
Dev hardware: Mac OS X 10.4 PowerPC, Keyspan USA-19HS, Atmel
STK500v2, 10-pin ISP cable to target system.
Dev software: OSX-AVR: avrdude 5.3.1
I had a working ATmega8 system running with an internal oscillator at
the default rate of 1 MHz. My customer wants to run at 8 MHz, so I
used avrdude to set the fuse bits like this:
$ avrdude -p atmega8 -P /dev/cu.KeySerial1 -c stk500v2 -V -t
avrdude> write lfuse 0 0xE8
>>> write lfuse 0 0xE8
avrdude> read lfuse
>>> read lfuse
0000 e8
|. |
avrdude> quit
>>> quit
As you can see, I used the value 0xE8, not 0xE4 like I should have.
Now, I cannot reconnect via avrdude:
$ avrdude -p atmega8 -P /dev/cu.KeySerial1 -c stk500v2 -V -t
avrdude: stk500v2_command(): command failed
avrdude: initialization failed, rc=-1
Double check connections and try again, or use -F to override
this check.
avrdude done. Thank you.
I have tried setting the bit clock by adding this to the command
line, "-B 1.0" on up to "-B 4.0" with no luck. I have tried chip
erase "-e" with no luck. Is there a way for me to re-establish comms
with the ATmega8? Resetting the fuses to defaults would be nice.
!!Dean
_______________________________________________
AVR-chat mailing list
AVR-chat@nongnu.org
http://lists.nongnu.org/mailman/listinfo/avr-chat
