I get the following error message when trying to program the eeprom of an at90can128:
stk500v2_paged_write: loadpage instruction not defined for part "AT90CAN128" I'm using avrdude 5.0. The full output is at the end of this message. According to avrdude.conf, avrdude shouldn't even be trying to used paged writes for eeprom. I remember having to change read->read_lo and write->write_lo in 5.0-BETA but this error seems to be slightly different. -- Daniel avrdude -c avrispv2 -p at90can128 -P /dev/tts/1 -e -U flash:w:avrforth.hex:i -U eeprom:w:avrforth.eep.hex:i avrdude: AVR device initialized and ready to accept instructions Reading | ################################################## | 100% 0.01s avrdude: Device signature = 0x1e9781 avrdude: erasing chip avrdude: reading input file "avrforth.hex" avrdude: writing flash (130528 bytes): Writing | ################################################## | 100% 1.07s avrdude: 130528 bytes of flash written avrdude: verifying flash memory against avrforth.hex: avrdude: load data flash data from input file avrforth.hex: avrdude: input file avrforth.hex contains 130528 bytes avrdude: reading on-chip flash data: Reading | ################################################## | 100% 28.07s avrdude: verifying ... avrdude: 130528 bytes of flash verified avrdude: reading input file "avrforth.eep.hex" avrdude: writing eeprom (10 bytes): Writing | avrdude: stk500v2_paged_write: loadpage instruction not defined for part "AT90CAN128" ################################################## | 100% 0.00s avrdude: failed to write eeprom memory, rc=-1 avrdude: safemode: Fuses OK avrdude done. Thank you. _______________________________________________ avrdude-dev mailing list [email protected] http://lists.nongnu.org/mailman/listinfo/avrdude-dev
