URL:
<http://savannah.nongnu.org/bugs/?func=detailitem&item_id=16156>
Summary: Problem with Si-Prog
Project: AVR Downloader/UploaDEr
Submitted by: None
Submitted on: Срд 22.03.2006 at 17:04
Category: None
Severity: 3 - Normal
Priority: 5 - Normal
Item Group: None
Status: None
Privacy: Public
Assigned to: None
Originator Name: RmRm
Originator Email: [EMAIL PROTECTED]
Open/Closed: Open
_______________________________________________________
Details:
I use AVRdude in WinAVR (editor Programmers Notepad-2) with consecutive
adapter SiProg (COM-port). Controllers AVR are programmed normally. However
at end of programming on line RES send a low level (RES=0) and the controller
is not started, therefore it is necessary to disconnect physically SiProg from
a controller. It is necessary to make in AVRdude so that upon end of
programming on lines of COM-port high level RES=1 has been established.
_______________________________________________________
Carbon-Copy List:
CC Address | Comment
------------------------------------+-----------------------------
r1973r --СБК-- yandex --ТЧК-- ru | Originator Email
_______________________________________________________
Reply to this item at:
<http://savannah.nongnu.org/bugs/?func=detailitem&item_id=16156>
_______________________________________________
Message sent via/by Savannah
http://savannah.nongnu.org/
_______________________________________________
avrdude-dev mailing list
[email protected]
http://lists.nongnu.org/mailman/listinfo/avrdude-dev
