Follow-up Comment #1, bug #26703 (project avrdude):
> The RTS output is connected to AVR reset
> via a 100 ohm resistor.
This resistor (R2) is not populated on the Arduino-Duemilanove boards
(checked on a ATmega168 and a ATmega328 Duemilanove board).
The only way to reset a Arduino-Duemilanove board is the following sequence:
1. set DTR (+5V on the FDTI chip) for more than 2ms to discharge C13 (100nF)
via R1 (10kOhm)
2. clear DTR (0V on the FDTI chip) for more than 2ms to bring nRESET of the
ATmega to a 0V level
_______________________________________________________
Reply to this item at:
<http://savannah.nongnu.org/bugs/?26703>
_______________________________________________
Nachricht geschickt von/durch Savannah
http://savannah.nongnu.org/
_______________________________________________
avrdude-dev mailing list
[email protected]
http://lists.nongnu.org/mailman/listinfo/avrdude-dev
