2011/3/14 <[email protected]>: > IgorsGentooOnNetwork igor # dmesg | grep b43 > [ 0.164260] b43-pci-bridge 0000:0b:00.0: PCI INT A -> GSI 16 (level, low) > -> IRQ 16 > [ 0.164280] b43-pci-bridge 0000:0b:00.0: setting latency timer to 64 > [ 4.048785] b43-phy0: Broadcom 4311 WLAN found (core revision 10) > [ 4.065927] b43-phy0 debug: Found PHY: Analog 4, Type 2, Revision 8 > [ 4.065955] b43-phy0 debug: Found Radio: Manuf 0x17F, Version 0x2050, > Revision 2 > [ 98.027122] b43 ssb0:0: firmware: requesting b43/ucode5.fw > [ 98.090329] b43 ssb0:0: firmware: requesting b43/pcm5.fw > [ 98.100037] b43 ssb0:0: firmware: requesting b43/b0g0initvals5.fw > [ 98.122736] b43 ssb0:0: firmware: requesting b43/b0g0bsinitvals5.fw > [ 98.239075] b43-phy0: Loading firmware version 410.2160 (2007-05-26 > 15:32:10) > [ 98.280131] b43-phy0 debug: Chip initialized > [ 98.280340] b43-phy0 debug: 32-bit DMA initialized > [ 98.289255] b43-phy0 debug: Wireless interface started > [ 98.292566] b43-phy0 debug: Adding Interface type 2 > [ 98.295050] b43-phy0: Radio turned on by software > [ 99.560554] b43-phy0 debug: Using hardware based encryption for keyidx: 0, > mac: 00:22:3f:7d:63:6a > [ 99.560615] b43-phy0 debug: Using hardware based encryption for keyidx: 1, > mac: ff:ff:ff:ff:ff:ff > [ 812.496128] b43-phy0 debug: Using hardware based encryption for keyidx: 2, > mac: ff:ff:ff:ff:ff:ff > [ 1430.108269] b43-phy0 debug: Disabling hardware based encryption for > keyidx: 0, mac: 00:22:3f:7d:63:6a > [ 1430.110089] b43-phy0 debug: Disabling hardware based encryption for > keyidx: 1, mac: ff:ff:ff:ff:ff:ff > [ 1430.110109] b43-phy0 debug: Disabling hardware based encryption for > keyidx: 2, mac: ff:ff:ff:ff:ff:ff > [ 1432.117592] b43-phy0 debug: Using hardware based encryption for keyidx: 0, > mac: 00:22:3f:7d:63:6a > [ 1432.117654] b43-phy0 debug: Using hardware based encryption for keyidx: 2, > mac: ff:ff:ff:ff:ff:ff > > Now to the problem. > I boot my laptop, then execute following commands: > IgorsGentooOnNetwork igor # cat ./setup_wireless > ifconfig wlan0 up > wpa_supplicant -c/etc/wpa_supplicant/wpa_supplicant.conf -iwlan0 -B > dhcpcd wlan0 -d > > I am getting an IP without any problems. I can browse web without any > problems. > However if I leave the laptop for some time and then come back and refresh > the page on the browser > I see that I'm not connected to my AP. Instead it connects to the AP that is > located in the office > and it asks for the AP credentials. > The laptop is running an "ivman" - daemon to do memory swap.
There are not any b43 errors in dmesg and considering your scenario I don't think driver has anything to do with this. I don't understand your part: "it asks for the AP credentials". What do you mean by "it"? AFAIK wpa_supplicant does not have interactive mode. The situation sounds pretty simple. Your connection was broken (that happens in WiFI, with every card/driver) and SOMETHING tries to connect to another AP you configured... -- Rafał _______________________________________________ b43-dev mailing list [email protected] http://lists.infradead.org/mailman/listinfo/b43-dev
