On 04/21/2011 01:31 PM, francesco.gring...@ing.unibs.it wrote:
Hello Michael,
I'm doing experiments sending greedy udp traffic from a b43 station to a b43 access
point. I have noticed that switching from 2.6.34-rc7 to 2.6.35 the sendmsg call becomes
"almost" non blocking when sending from a Broadcom nic while it is still as
usual with other nics.
If I load the channel with a 54Mb/s iperf stream (iperf -b54M ...) on< 2.6.35
I see that the application is blocked times to times when calling sendmsg() so
that it is slowed down to the channel capabilities and packets are not internally
dropped. Clearly they can still be lost on the air :-)
With>= 2.6.35 the application is never blocked and all the packets exceeding
the channel capabilities are internally lost by the kernel: in particular it is
the asynchronous tx worker (b43_tx_work) that drops them, since it calls
b43_dma_tx even if the interface has been stopped because the dma FIFO queue was
full. Apart from packets being lost, the CPU load increases since packets cross
all the kernel code, from udp_sendmsg down to b43_dma_tx even if they will be
dropped.
I don't think this is the expected behavior on Linux: I did some testing to
check what happens with other devices and I can experience only the first
behavior on Intel and Atheros WiFi nics as well as on Fast Ethernet nics (in
this case I run iperf -b100M :-) independently of the kernel version.
Strangely the b43 sources in 2.6.35 are really similar to those in 2.6.34-rc7 and
the differences do not seem to justify the different behavior. There are also
other weird observations (like qdisc never used in< 2.6.34-rc7) but I would
like to have a first opinion from your side.
Many thanks,
-Francesco
P.S. what reported does not depend on the firmware version. I also tried a few
cards (4306, 4311 and 4318) and nothing changed.
Francesco,
I agree that there are no changes in b43 between 2.6.34-rc7 and 2.6.35 that
would cause this problem. All but one of the changes are for N PHYs, and that
one only removes some braces that are not needed. In addition, there are no
changes in ssb that would affect anything other than SPROM loading.
Have you tried your test with a 2.6.38 kernel? Perhaps the problem has already
been fixed. The other thing to do would be to try to bisect between .35 and
.34-rc7. If you do that, consider the entire kernel, not just b43. If it is
impossible for you to do either of the tests, please send me any command files
that you are using, and I'll try it here.
Larry
_______________________________________________
b43-dev mailing list
b43-dev@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/b43-dev
