On 03/06/2012 11:11 PM, Rafał Miłecki wrote:
> By using reverted mask we were taking over pins we were not supporsed to
> touch. After fixing this workaround for BCM5354 should not be needed
> anymore.
> 
> Signed-off-by: Rafał Miłecki <zaj...@gmail.com>
> ---
>  drivers/net/wireless/b43/main.c |    6 ++----
>  1 files changed, 2 insertions(+), 4 deletions(-)
> 
> diff --git a/drivers/net/wireless/b43/main.c b/drivers/net/wireless/b43/main.c
> index 1d633f3..8a89885 100644
> --- a/drivers/net/wireless/b43/main.c
> +++ b/drivers/net/wireless/b43/main.c
> @@ -2706,8 +2706,6 @@ static int b43_gpio_init(struct b43_wldev *dev)
>               mask |= 0x0060;
>               set |= 0x0060;
>       }
> -     if (dev->dev->chip_id == 0x5354)
> -             set &= 0xff02;
>       if (0 /* FIXME: conditional unknown */ ) {
>               b43_write16(dev, B43_MMIO_GPIO_MASK,
>                           b43_read16(dev, B43_MMIO_GPIO_MASK)
> @@ -2730,7 +2728,7 @@ static int b43_gpio_init(struct b43_wldev *dev)
>       case B43_BUS_BCMA:
>               bcma_cc_write32(&dev->dev->bdev->bus->drv_cc, BCMA_CC_GPIOCTL,
>                               (bcma_cc_read32(&dev->dev->bdev->bus->drv_cc,
> -                                     BCMA_CC_GPIOCTL) & mask) | set);
> +                                     BCMA_CC_GPIOCTL) & ~mask) | set);
>               break;
>  #endif
>  #ifdef CONFIG_B43_SSB
> @@ -2739,7 +2737,7 @@ static int b43_gpio_init(struct b43_wldev *dev)
>               if (gpiodev)
>                       ssb_write32(gpiodev, B43_GPIO_CONTROL,
>                                   (ssb_read32(gpiodev, B43_GPIO_CONTROL)
> -                                 & mask) | set);
> +                                 & ~mask) | set);
>               break;
>  #endif
>       }

Hi,

This patch did not helped fixing my problem. The ucode still takes over
the GPIOs of the buttons with firmware version 666.2. I am getting the
following messages:

[   83.620000] b43-phy0: Loading firmware version 666.2 (2011-02-23
01:15:07)
[   83.624000] Init value of B43_GPIO_CONTROL: 0x0
[   83.632000] b43-phy0 debug: b2062: Using crystal tab entry 19200 kHz.
[   83.640000] hotplug_button: action: pressed, name: reset, seen: 17179652
[   83.644000] hotplug_button: action: pressed, name: ses, seen: 17179652
[   89.404000] b43-phy0 debug: Chip initialized


_______________________________________________
b43-dev mailing list
b43-dev@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/b43-dev

Reply via email to