On 24 June 2014 18:57, Camille Prevost <c...@home108.com> wrote: > Thank you for this quick reply :) > > I firstly tried to : echo "14e4 4350" > > /sys/bus/pci/drivers/b43-pci-bridge/new_id , then I obtain this at the end > of my dmesg : > > ... > [13660.804224] ssb: Core 0 found: ChipCommon (cc 0x800, rev 0x1E, vendor > 0x4243) > [13660.804256] ssb: Core 1 found: IEEE 802.11 (cc 0x812, rev 0x10, vendor > 0x4243) > [13660.804282] ssb: Core 2 found: PCI (cc 0x804, rev 0x0E, vendor 0x4243) > [13660.824164] ssb: ERROR: PLL init unknown for device A8D6 > [13660.840150] ssb: ERROR: PMU resource config unknown for device A8D6 > [13660.892434] b43-phy0: Broadcom 43222 WLAN found (core revision 16) > [13660.960697] ieee80211 phy0: Selected rate control algorithm 'minstrel_ht' > [13660.977285] Registered led device: b43-phy0::tx > [13660.978336] Registered led device: b43-phy0::rx > [13660.979534] Registered led device: b43-phy0::radio > [13660.979570] ssb: Sonics Silicon Backplane found on PCI device 0000:00:0c.0 > > (...) > > Should I really compile a 3.8 kernel as suggested ? I surely can, but not > immediately, because the Compact Flash I use is too small for this ... ! > > But if you think it's better (for keeping ID after reboot), I will do... > and give you a feedback surely !
Please keep discussion on the list. New kernels have some improvements, not just bigged IDs database. There were some fixes for N-PHY and kernel 3.16 will bring even more fixes (correct handling of radio rev 11). See how well 3.2 works for you and in case of problems think about update. _______________________________________________ b43-dev mailing list b43-dev@lists.infradead.org http://lists.infradead.org/mailman/listinfo/b43-dev
