Any value is allowed, but the meaningful values are between 0 and 10.
Increasing the value generates more log output. At XferLogLevel == 1 you
should get one line of output per file, and it goes up from there.
If I'm trying to track down a problem, I usually start at 7.
You can also get addition log output from rsync_bpc (and rsync) using the
--debug option. Run "rsync --debug=help" to see the options. There is one
for ACLs, so add "--debug=ACL" to $Conf{RsyncArgsExtra}. Or you can add
one or more -v options, eg: "-vvvv".
I'll reply to your earlier question about acls.
Craig
On Sun, Jun 4, 2017 at 5:31 AM, Robert Wooden <b...@donelsontrophy.com>
wrote:
> I have v4.1.2 running and would like to increase the log level.
> What is the range of settings allowed with "XferLogLevel"? Zero (0)
> through 10?
>
> Is there some other log setting I have overlooked?
>
> I am trying to find log information regarding "acls" and "xattrs" file
> attributes.
>
> --
>
> Thank you,
>
>
> Bob Wooden
>
>
> ------------------------------------------------------------
> ------------------
> Check out the vibrant tech community on one of the world's most
> engaging tech sites, Slashdot.org! http://sdm.link/slashdot
> _______________________________________________
> BackupPC-users mailing list
> BackupPC-users@lists.sourceforge.net
> List: https://lists.sourceforge.net/lists/listinfo/backuppc-users
> Wiki: http://backuppc.wiki.sourceforge.net
> Project: http://backuppc.sourceforge.net/
>
>
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
BackupPC-users mailing list
BackupPC-users@lists.sourceforge.net
List: https://lists.sourceforge.net/lists/listinfo/backuppc-users
Wiki: http://backuppc.wiki.sourceforge.net
Project: http://backuppc.sourceforge.net/
