loaderinfo on all of the /dev/sg* devices gave me "cannot open SCSI device
'/dev/sgx' - No such device or address"
there is no /sys/class/scsi_generic
[EMAIL PROTECTED]:/sys/class# ls -1
cpuid/
dmi/
fc_host/
fc_remote_ports/
fc_transport/
fc_vports/
firmware/
input/
iscsi_connection/
iscsi_host/
iscsi_session/
iscsi_transport/
mem/
misc/
msr/
net/
pci_bus/
raid_devices/
sas_device/
sas_end_device/
sas_expander/
sas_host/
sas_phy/
sas_port/
scsi_changer/
scsi_device/
scsi_disk/
scsi_host/
scsi_tape/
spi_host/
spi_transport/
tty/
usb_endpoint/
usb_host/
vc/
vtconsole/
I looked in scsi_changer and there is sch0 but loaderinfo will not load that
either.
On Dec 11, 2007 2:22 PM, Chris Howells <[EMAIL PROTECTED]>
wrote:
> Gary Danko wrote:
>
> > dmesg shows that the library (ch0) and all four drives (st0-st3) are
> > recognized, but /dev/ch0 does not exist and only /dev/st0 and /dev/st1
> > exist. Please see the attached dmesg output:
>
> >
> > Any ideas why I am seeing this behavior?
>
> Autochangers are accessed using /dev/sgN, where N is an integer. I'm not
> sure if there is an easy way to find out the device, other than trial
> and error, the easiest way to find out the device, see
> /sys/class/scsi_generic for a list of all the possible devices.
>
-------------------------------------------------------------------------
SF.Net email is sponsored by:
Check out the new SourceForge.net Marketplace.
It's the best place to buy or sell services for
just about anything Open Source.
http://sourceforge.net/services/buy/index.php
_______________________________________________
Bacula-users mailing list
Bacula-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/bacula-users
