Hello all
I have been working on adding a HP Overland 8 tape drive to my Bacula backup
system.
I have the system recognizing the tape and autoloader.
I can run mt and mtx command. I can write to and read from the tapes. I was
able to successfully run btape test and autochanger but when I ran the (fill)
test the device would be removed from /dev and the test would fail. I then need
to power cycle the device.
I have looked at dmesg and there is nothing reported about btape or the
devices. I have rebooted the server. I have reset the device to factory
default. I have also powered the device off for at least 15 minutes.
Any advice would be great.
Daniel Hicks
Senior Systems Analyst
FutureWorld Technologies Inc.
DMEA IT Support
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Bacula-users mailing list
Bacula-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/bacula-users
