On Dec 19, 2007 3:52 PM, Robert Denton <[EMAIL PROTECTED]> wrote:
> Two things:
>
> 1. Trying to install barry-util I get this: error: Failed dependencies:
> libboost_serialization.so.2 is needed by barry-util-0.11-1.i386 Not sure
> if anyone else encountered that.
>
> 2. after installing the various rpms I get the following when trying to
> run bcharge:
>
> [EMAIL PROTECTED] 10]# bcharge
> Scanning for Blackberry devices...
> Found device #005...adjusting charge setting...adjusting Pearl mode to
> dual
> usb_reset failed: could not reset: No such device
> ...done
>
> It is encouraging that it was trying to adjust the charge settings
> although it looks like there is still a small problem. Has anyone
> encountered this?
>
On this you need to remove the usb_storage module. So run sudo modprobe -r
usb_storage and then run bcharge again. that should set cause the
blackberry to go to the right mode.
Nathan
-------------------------------------------------------------------------
SF.Net email is sponsored by:
Check out the new SourceForge.net Marketplace.
It's the best place to buy or sell services
for just about anything Open Source.
http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/marketplace
_______________________________________________
Barry-devel mailing list
Barry-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/barry-devel
