After reading through the mailing list archives I was able to learn that I would need the latest CVS version in order to get my new Curve 8330 up and working with Barry. I got all the -dev packages downloaded and barry compiled just fine.
I went through the whole ./buildgen.sh, ./configure, and make process smoothly. However it seemed necessary for me to run make install using sudo privileges for it to install properly. When I run btool as my normal user I am given the following error: Usb::Error caught: (-1, error sending control message: Operation not permitted): Probe: GetConfiguration failed However, if I run btool using sudo it connects just fine. This makes syncing next to impossible, because opensync can't connect unless I also run them with sudo privileges, which then messes up the privileges for the programs I'm trying to sync to. My experiences were the same using barrybackup (same error unless using sudo.) Any suggestions for how I might be able to run these tools without needing to use sudo privileges? Thanks so much! ------------------------------------------------------------------------- Check out the new SourceForge.net Marketplace. It's the best place to buy or sell services for just about anything Open Source. http://sourceforge.net/services/buy/index.php _______________________________________________ Barry-devel mailing list Barry-devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/barry-devel
