Larry, As I wrote in the E-mail to the previous patch for the LED switching, it didn't work. Just a refreshment: I am using the 2.6.18 kernel with the Gentoo Linux patches. My card is a Dell Wireless 1309 Mini-PCI card, which translates into the 4311 Broadcom. And I am using it on the Dell E1505 laptop.
Now, about this patch. First, is it suppose to work with all 43xx cards or it is targeted for bcm4306 rev 3 only? Second, should I apply it on top of the previous LED patch or just for the kernel tree? I.e. should I remove any references to the led[0], led[1] and led[2]? Thank you. -----Original Message----- >From: Larry Finger <[EMAIL PROTECTED]> >Sent: Dec 20, 2006 3:49 PM >To: "Jory A. Pratt" <[EMAIL PROTECTED]> >Cc: bcm43xx devel <[email protected]> >Subject: Re: bcm43xx-softmac code to handle (at least one) iface with an >rfkill switch > >Jory A. Pratt wrote: >>> >> It would be nice if this would apply against 2.6.19.1 :) not too many of >> us are ready to jump all the way out to 2.6.20_rc1 as we know just how >> buggy it is with the new changes to workqueue >> >> Thanks For your work your doing an awsome job. > >Wireless-2.6 is a 2.6.19 kernel. The difference that broke the patch is that >wireless-2.6 has a >patch that gets rid of the "badness" calculation, whereas 2.6.19 still has it. > >The revised patch for 2.6.19.1 is attached. > >Incidentally, except for the patch for ieee80211softmac that has been recently >discussed here, I'm >having no problems with 2.6.20-rc1. > >Larry _______________________________________________ Bcm43xx-dev mailing list [email protected] https://lists.berlios.de/mailman/listinfo/bcm43xx-dev
