From: Joerg Sommer <[EMAIL PROTECTED]>
The frequency to channel routine in bcm43xx requires that the frequency
be in MHz, but that condition is not always met. This patch does the
necessary conversion.
Signed-off-by: Joerg Sommer <[EMAIL PROTECTED]>
Signed-off-by: Larry Finger <[EMAIL PROTECTED]>
---
Index: wireless-2.6/drivers/net/wireless/bcm43xx/bcm43xx_wx.c
===================================================================
--- wireless-2.6.orig/drivers/net/wireless/bcm43xx/bcm43xx_wx.c
+++ wireless-2.6/drivers/net/wireless/bcm43xx/bcm43xx_wx.c
@@ -106,18 +106,24 @@ static int bcm43xx_wx_set_channelfreq(st
struct bcm43xx_private *bcm = bcm43xx_priv(net_dev);
unsigned long flags;
u8 channel;
+ s8 expon;
int freq;
int err = -EINVAL;
mutex_lock(&bcm->mutex);
spin_lock_irqsave(&bcm->irq_lock, flags);
- if ((data->freq.m >= 0) && (data->freq.m <= 1000)) {
+ if ((data->freq.e == 0) &&
+ (data->freq.m >= 0) && (data->freq.m <= 1000)) {
channel = data->freq.m;
freq = bcm43xx_channel_to_freq(bcm, channel);
} else {
- channel = bcm43xx_freq_to_channel(bcm, data->freq.m);
freq = data->freq.m;
+ expon = 6 - data->freq.e;
+ while (--expon >= 0) /* scale down the frequency to MHz */
+ freq /= 10;
+ assert(freq > 1000);
+ channel = bcm43xx_freq_to_channel(bcm, freq);
}
if (!ieee80211_is_valid_channel(bcm->ieee, channel))
goto out_unlock;
---
_______________________________________________
Bcm43xx-dev mailing list
[email protected]
https://lists.berlios.de/mailman/listinfo/bcm43xx-dev
