Johan Ehnberg wrote: > Hi, > > I have more to report today. I was able to connect to the network now, > but the connection is sluggish at least with WPA, and eventually > disconnects. I am getting a lot of the following messages: > > [ 477.704000] printk: 2 messages suppressed. > [ 484.516000] printk: 1 messages suppressed. > > But I didn't find out which messages are being suppressed. I also > couldn't reconnect, so I switched to ndiswrapper to send you this.
I also get the unexplained printk suppressed messages that I don't understand. I also do not understand the sluggish performance from your BCM4312. I though it had the same radio and PHY as the 4311. If you have seen my previous reports of performance on the 4306, 4318 and 4311 chips, all of them were run with WPA enabled. I don't run any other way. Please use iwconfig to check the rate that is set. It should be 24M. If not, try setting that rate. If it is 24M, try 11M, which usually helps an interface that is having trouble at 24M. Your peak rate is diminished but the throughput is much better because of fewer retransmits. Larry _______________________________________________ Bcm43xx-dev mailing list [email protected] https://lists.berlios.de/mailman/listinfo/bcm43xx-dev
