Sorry, I got it all fixed. The XP installation on my system had the file. There is a warning that says
Warning! Idle-TSSI.... Disabling TX power adjustment. But I assume it's nothing? Hopefully this doesn't have the speed problems that required a patch before. Thanks again! On 6/1/07, John H. <[EMAIL PROTECTED]> wrote: > I mean, the correct files to populate /lib/firmware(as I assume that's > what you mean). > > I don't see it, or the instructions, on > http://bcm43xx.berlios.de/ > > On 6/1/07, John H. <[EMAIL PROTECTED]> wrote: > > Thanks for the prompt response. > > > > I have a dell e1505. Do I need an updated fwcutter as well? What is > > the actual driver I need? The device is broadcom 1390? > > > > > > On 6/1/07, Larry Finger <[EMAIL PROTECTED]> wrote: > > > John H. wrote: > > > > bcm43xx mac80211: > > > > YOUR FIRMWARE IS TOO OLD. Firmware from binary drivers older than > > > > version 4.x is unsupported. You must upgrade your firmware files. > > > > > > > > I get that now with f7 and 2.6.21 and didn't with fc6 2.6.20. > > > > > > > > However, I read that the error is not what it sounds like. What is > > > > the solution? > > > > > > The error is _EXACTLY_ what it sounds like. With fc6, you were using > > > bcm43xx-softmac, which uses V3 > > > firmware. With fc7, you switched to bcm43xx-mac80211, which needs V4 > > > firmware - just what the error > > > message said. The solution is to download a V4 driver and create the > > > appropriate firmware. > > > > > > Larry > > > > > > _______________________________________________ Bcm43xx-dev mailing list [email protected] https://lists.berlios.de/mailman/listinfo/bcm43xx-dev
