This patch changes the printouts of the initial state of the
radio on/off switch from debug to normal mode. The change is
needed because some distros have debug disabled in their precompiled
drivers, which complicates the initial troubleshooting.
Signed-off-by: Larry Finger <[EMAIL PROTECTED]>
CC: Michael Buesch <[EMAIL PROTECTED]>
---
main.c | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
Index: wireless-dev/drivers/net/wireless/b43legacy/main.c
===================================================================
--- wireless-dev.orig/drivers/net/wireless/b43legacy/main.c
+++ wireless-dev/drivers/net/wireless/b43legacy/main.c
@@ -2046,7 +2046,7 @@ static int b43legacy_chip_init(struct b4
goto err_gpio_cleanup;
b43legacy_radio_turn_on(dev);
dev->radio_hw_enable = b43legacy_is_hw_radio_enabled(dev);
- b43legacydbg(dev->wl, "Radio %s by hardware\n",
+ b43legacyinfo(dev->wl, "Radio %s by hardware\n",
(dev->radio_hw_enable == 0) ? "disabled" : "enabled");
b43legacy_write16(dev, 0x03E6, 0x0000);
@@ -2175,7 +2175,7 @@ static void b43legacy_periodic_every1sec
radio_hw_enable = b43legacy_is_hw_radio_enabled(dev);
if (unlikely(dev->radio_hw_enable != radio_hw_enable)) {
dev->radio_hw_enable = radio_hw_enable;
- b43legacydbg(dev->wl, "Radio hardware status changed to %s\n",
+ b43legacyinfo(dev->wl, "Radio hardware status changed to %s\n",
(radio_hw_enable == 0) ? "disabled" : "enabled");
b43legacy_leds_update(dev, 0);
}
_______________________________________________
Bcm43xx-dev mailing list
[email protected]
https://lists.berlios.de/mailman/listinfo/bcm43xx-dev
