Hello all, After using bcm43xx for a long time (courtesy of Larry) on my compaq v3019us I though I would test the b43 so I go it from git last night. I used the current v4 firmware and the b43 driver seemed to load fine until it hit an error relating to ssb. I am using mac80211 not softmac and I tried the b43legacy with mac80211 as well all to the same effect. I tried the ssb initcall ordering patch that was just released with b43 again to no effect. My machine is a laptop with the bcm4311 version 1 the cpu is an amd turion 64 and it is running smp. Is there a 64 bit firmware I should be using? I configured the kernel exactly the same as I have in the past only with the new mac80211, b43, and rfkill switch supported as modules. Is this an SSB problem or an error in b43 and can someone please help me? I turned verbose on but it didn't help much. Below is a snippet of my dmesg output.
ssb: Core 0 found: ChipCommon (cc 0x800, rev 0x11, vendor 0x4243) ssb: Core 1 found: IEEE 802.11 (cc 0x812, rev 0x0A, vendor 0x4243) ssb: Core 2 found: USB 1.1 Host (cc 0x817, rev 0x03, vendor 0x4243) ssb: Core 3 found: PCI-E (cc 0x820, rev 0x01, vendor 0x4243) ssb: Sonics Silicon Backplane found on PCI device 0000:01:00.0 b43-phy1: Broadcom 4311 WLAN found b43-phy1 debug: Found PHY: Analog 4, Type 2, Revision 8 b43-phy1 debug: Found Radio: Manuf 0x17F, Version 0x2050, Revision 2 phy1: Failed to select rate control algorithm phy1: Failed to initialize rate control algorithm b43: probe of ssb0:0 failed with error -2 _______________________________________________ Bcm43xx-dev mailing list [email protected] https://lists.berlios.de/mailman/listinfo/bcm43xx-dev
