DeckerXL wrote: > I'm using a bcm43xx wireless adapter in Linux and running Kismet in > Backtrack2 (BackTrack 2 Stable release Mar 06 2007) > Works fine except that I'm not getting signal strength & noise values > from the wifi adapter in Kismet. Do you know why? > > The specific wifi cardbus card I'm using is: > Buffalo WLI-PCI-G54 4306 > > In Kismet, I get the value 0 (zero) for Signal Strength (Sgn) and > Noise (Nse) columns. Do you know why? > > I also did the firmware upgrade as listed on your support page for > bcm43xx: with no effect. > For bcm43xx: 'sudo bcm43xx-fwcutter -w /lib/firmware > wl_apsta-3.130.20.0.o'
What kernel does Backtrack2 run? Send the output of 'uname -r'. There have been a lot of changes in bcm43xx over the past 9 months. I cannot say which of them might have affected the Kismet results. Larry _______________________________________________ Bcm43xx-dev mailing list [email protected] https://lists.berlios.de/mailman/listinfo/bcm43xx-dev
