hi, On Tue, Jun 24, 2008 at 7:43 AM, Stefanik Gábor <[EMAIL PROTECTED]> wrote:
> On Tue, Jun 24, 2008 at 11:35 AM, Michael Buesch <[EMAIL PROTECTED]> wrote: > > On Tuesday 24 June 2008 05:26:21 Larry Finger wrote: > >> Ram kumar wrote: > >> > hi, > >> > I would like to know whether Broadcomm new wlan+Bluetooth > >> > BCM4325 module has linux driver support. > >> > > >> > I couldn't see any information on the website as well as in this > >> > website( > http://wireless.kernel.org/en/users/Drivers/b43#bcm43xx.2Cb43legacy.2Cb43.2Csoftmac.2C...thefullstory).Please<http://wireless.kernel.org/en/users/Drivers/b43#bcm43xx.2Cb43legacy.2Cb43.2Csoftmac.2C...thefullstory%29.Please> > >> > let us know about the driver support for this chip. > >> > >> There is unlikely to be any support for the Bluetooth. > > > > The BT device most likely is a seperate standard device that already > works. > > I have a 4318 with combined BT that just works fine. > > > > > > -- > > Greetings Michael. > > _______________________________________________ > > Bcm43xx-dev mailing list > > [email protected] > > https://lists.berlios.de/mailman/listinfo/bcm43xx-dev > > > Basically we need some information about the access point mode of the broadcomm modules.We are planning to configure the BCM4325 as an access point,meaning that the BCM4325 with the ATMEL AT91SAM9260 host processor will act as a access point,so that the any wireless device can connect to them as a client. Please guide us whether this can achieved by using BCM4325 module ? I have gone through the http://linuxwireless.org/en/users/Drivers/b43 website which says that broadcomm modules can be configured to access point mode....We want to know whether this module BCM4325 can be configured to work as an access point ? At present we are not too much concerned about bluetooth.....we want the wlan module to work for time being.... Regards, Ram
_______________________________________________ Bcm43xx-dev mailing list [email protected] https://lists.berlios.de/mailman/listinfo/bcm43xx-dev
