Fabio A. Correa wrote: > 2009/7/2 Larry Finger <[email protected]>: >> AFAIK, the phy driver is for wired devices. > OK, thanks. > >> Have you installed the firmware? Please look at the output of the command >> dmesg | egrep "ssb|b43|wlan0" > Yes, I have installed it. Here is some output from Syslog: > > Jul 2 08:56:16 [sudo] facorread : TTY=pts/0 ; PWD=/home/facorread ; > USER=root ; COMMAND=/sbin/modprobe -v b43 > Jul 2 08:56:16 [kernel] b43-pci-bridge 0000:06:00.0: PCI INT A -> GSI > 18 (level, low) -> IRQ 18 > Jul 2 08:56:16 [kernel] ssb: Core 0 found: ChipCommon (cc 0x800, rev > 0x11, vendor 0x4243) > Jul 2 08:56:16 [kernel] ssb: Core 1 found: IEEE 802.11 (cc 0x812, rev > 0x0A, vendor 0x4243) > Jul 2 08:56:16 [kernel] ssb: Core 2 found: USB 1.1 Host (cc 0x817, > rev 0x03, vendor 0x4243) > Jul 2 08:56:16 [kernel] ssb: Core 3 found: PCI-E (cc 0x820, rev 0x01, > vendor 0x4243) > Jul 2 08:56:16 [kernel] ssb: Sonics Silicon Backplane found on PCI > device 0000:06:00.0 > Jul 2 08:56:16 [kernel] b43-phy1: Broadcom 4311 WLAN found (core revision 10) > > Jul 2 08:56:21 [sudo] facorread : TTY=pts/0 ; PWD=/home/facorread ; > USER=root ; COMMAND=/etc/init.d/net.wlan0 start > Jul 2 08:56:21 [kernel] b43 ssb0:0: firmware: requesting b43/ucode5.fw > Jul 2 08:56:22 [kernel] b43 ssb0:0: firmware: requesting b43/pcm5.fw > Jul 2 08:56:22 [kernel] b43 ssb0:0: firmware: requesting b43/b0g0initvals5.fw > Jul 2 08:56:22 [kernel] b43 ssb0:0: firmware: requesting > b43/b0g0bsinitvals5.fw > Jul 2 08:56:22 [kernel] b43-phy1: Loading firmware version 410.2160 > (2007-05-26 15:32:10) > Jul 2 08:56:22 [kernel] Registered led device: b43-phy1::tx > Jul 2 08:56:22 [kernel] Registered led device: b43-phy1::rx > Jul 2 08:56:22 [kernel] b43-phy1: Radio turned on by software > Jul 2 08:56:22 [kernel] ADDRCONF(NETDEV_UP): wlan0: link is not ready > Jul 2 08:56:22 [/etc/init.d/net.wlan0] WARNING: net.wlan0 has > started, but is inactive > >> The other kernel modules that are needed are mac80211 and friends; >> however, the Kconfig rules should ensure that mac80211 is built before >> you can actually build b43. > You are right; I set them to be built into the kernel.
Please send the output I requested! _______________________________________________ Bcm43xx-dev mailing list [email protected] https://lists.berlios.de/mailman/listinfo/bcm43xx-dev
